DURABLE 5087 Traducción Del Manual Original página 29

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
Fixing the monitor arm on the table column
▶ siehe Abbildung 6
– Insert the arm bracket (4) in the table column (5) from top. Gui-
de the slot nut (11) of the arm bracket into the groove of the
table column.
– Fix the arm bracket (4) at the desired height using the adjusting
screw (12).
Fixing the brackets
▶ siehe Abbildung 7
– Slide the monitor bracket (2) or tablet bracket (19) right and left
over the monitor arm (3).
– Fix the position of brackets using the respective adjusting screw
(13).
Note:
Ensure that the brackets are fixed on the monitor arm
such that the adjusting screws are at the bottom.
▶ siehe Abbildung 8
– Place the cap (17) on the table column and end caps (18) on the
monitor arm.
Monitor mount
▶ siehe Abbildung 9
– Lay the monitor on a flat surface with the display facing down-
wards. Place a cover or similar under it for protection.
– Remove any coverings in the mount area of the VESA plate (1)
on the monitor. Consult the monitor manufacturer's operating
instructions.
– Fasten the VESA plate  (1) to the monitor with the enclosed
screws  (20). Make sure that the plate is properly located. The
clamps must show the upper edge of the monitor.
– Insert the enclosed covering cap (21).
EN
English
29

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

5088

Tabla de contenido