Routine Cleaning - Guardian Technologies Germ Guardian NS2000 Instrucciones De Uso Y Cuidado

Cover
base
Indicator
Light
rubber Feet
DIrECTIoNS For uSE
this appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug
will fit in a polarized outlet only one way. if the plug does not fit fully in the outlet, reverse the plug.
if it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
1. Place heat resistant, dishwasher 2. Secure lid.
safe objects into the wide
clear-view sanitizing chamber.
Do nOt overfill chamber.
4. Press On button to begin
sanitizing cycle. Remember not
to leave sanitizer unattended
during sanitizing cycle.
nOtE: You may terminate the sanitizing cycle at any time by pressing and releasing the On/OFF
button. the indicator light will blink and the fan will continue to operate up to eight minutes to cool
the sanitizer. nursery products must be subjected to the complete 30-minute cycle to be sanitized.
IT IS ExTrEMELY IMporTaNT THaT ITEMS pLaCED IN THE SaNITIzING CHaMbEr bE FrEE oF
ForEIGN MaTTEr aND arE NoT WET.
E-4
NS2000_0409_Manual.indd 3
removable
Sanitizing
Chamber
oN/oFF button
3. Place chamber on base.
5. Dry heat Sanitizer automatically
shuts off when cycle is complete.

rouTINE CLEaNING

it is recommended to occasionally wash the sanitizing chamber and cover. Remove the sanitizing
chamber and cover from the base and wash with warm water and mild detergent. Allow chamber and
lid to dry completely before replacing them on the base. it is nOt recommended to wash the sanitizing
chamber or cover in the dishwasher.
SELECTING THE approprIaTE NurSErY proDuCTS
• Do not sanitize electronic items with light or sound features as the heat may damage
the sensitive electronics.
• Do not sanitize liquid filled toys as a rupture in the product could create an electrical hazard.
• if you have any questions about what baby items or breast pump attachments can safely be
placed in the sanitizing chamber DO nOt PlACE the item in the chamber and contact the manu-
facturer of the item to determine the product's resistance to high heat or call 1.866.603.5900.
TroubLESHooTING GuIDE
the Germ Guardian Dry heat Sanitizer is provided with the capability of detecting and warning you of
improper usage and malfunction. the indicator light on the front panel will begin blinking to warn you
of a potential problem. Refer to the table below to resolve:
CauSES For bLINkING
INDICaTor LIGHT
operator interrupt:
button is depressed while product is
in process, resulting in blinking light.
automatic interrupt:
the light changes from steady to
blinking without operator intervention
while sanitizer is operating.
Continuous blinking indicator light.
SoLuTIoN
Allow up to 8 minutes for the light to go off, indi-
cating that the product has cooled sufficiently.
1. Allow up to 8 minutes for the light to
go off, indicating that the product has
cooled sufficiently.
2. Check for the following before initiating
next cycle:
• Sanitizing chamber and/or cover is
not in place.
• Sanitizing chamber is too full.
• Sanitizing chamber vents are blocked.
• house voltage is outside of normal limits.
Contact a qualified electrician.
Should any of the above operations result in a
blinking light, immediately unplug the Dry heat
Sanitizer and refer to the warranty section of
these instructions.
E-5
6/16/2009 3:22:05 PM