Fan Assembly. Pgs - Craftmade LOU52AGV4 Guia De Instalacion

All manuals and user guides at all-guides.com
5. Fan Assembly
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
set screw set screw hole
6in. downrod provided to use with an extended
stop pin
downrod (sold separately). [If you wish to use the
6in. downrod, please proceed to instructions
following the dotted line below.]
hanging ball
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove stop
pin. Slide hanging ball off the original downrod, A,
and slide it down the longer downrod, B (the top of
the downrod should be noted as having a set
A
screw hole; use this hole when setting the set
screw). Insert stop pin into top of extended
downrod and raise hanging ball. Be sure stop pin
B
aligns with slots on the inside of the hanging ball.
Tighten set screw securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
safety cable
keep the wires together when threading them
electrical wiring
through the downrod.
downrod
Locate canopy cover in hardware pack. Loosen
yoke set screws and nuts at top of motor housing.
canopy
Remove pin and clip from motor housing yoke.
Slide downrod through canopy, canopy cover and
yoke cover. [Note: Canopy cover must be turned
canopy cover
with shiny side toward the motor housing.]
yoke cover
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
yoke set screw
end of the downrod.
pin
clip
Thread downrod into the motor yoke until holes
for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip. Tighten yoke set screws and nuts
securely. Lower yoke cover to motor housing.
motor
["Fan Assembly" continued on next page.]
housing
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
page 4