Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DOME SETTINGS
The external dome and the internal dome must be removed in the following manner to set the address, the
baud rate and the communication protocol:
7.
Turn the external dome anticlockwise by approximately ¼ a turn to release it from its seat.
8.
Turn the internal dome anticlockwise by approximately ¼ a turn to release it from its seat.
9.
After removing the two parts, access the dip switches inside the dome.
10.
Use the small screwdriver (included) for making the necessary settings.
11.
Position the internal dome on the support making the holding tabs of the dome itself with the holes on
the support and turn it clockwise until it locks.
12.
Position the external dome on the support and turn it clockwise until it is blocked.
SETTING THE ADDRESS
The default address of the THERA 4 dome is 1.
To change the address according to the connected devices, use the dip switches on the PCD of the dome
as shown in the figure.
DEFAULT SETTINGS
ON
1
2
3
4
5
DS1092-041C
All manuals and user guides at all-guides.com
6
7
8
DOME ADDRESS CALCULATION EXAMPLE
ON
1
2
3
(2+4+16=22) The address is 22
DIP SWITCH
ON
1
2
3
1
2
4
8
5
4
6
7
8
4
5
6
7
8
128
64
32
16
47
Publicidad
Tabla de contenido
Solución de problemas
