Electrical Connection; Technical Data; Start Of Operation - KÜPPERBUSCH EKI 607.2 Instrucciones De Montaje

Instructions for assembly

Electrical connection

• The electrical connection must be carried out by a quali-
fied electrician who is authorised to carry out such work!
• Statutory regulations and the connection specifications issued
by the local power supply company must be strictly observed.
• When connecting the appliance it must be ensured that there
is a device which makes it possible to disconnect it from the
mains at all poles with a contact opening width of at least
3 mm. Line-protecting switches, fuses or contactors are sui-
table cut-out devices.
• When connecting and repairing the appliance disconnect it
from the electricity supply with one of these devices.
• The earth wire must be sufficiently long so that if the strain
relief fails, the live wires of the connecting cable are subjected
to tension before the earth wire.
• Any superfluous cable must be removed from the installation
area beneath the appliance.
• Make sure that the local mains voltage is the same as the
voltage on the rating label.
• To connect the appliance, unscrew the switchbox cover on the
underside of the appliance to access the terminal block. After
connecting the appliance, replace the cover and secure the
connection cable with the strain relief clamp.
• The connection cable must be at least H05 RR-F.
• If the excess cable of this appliance is damaged, it has to be
replaced by the manufacturer, the Customer Service of the
manufacturer or by another qualified person in order to avoid
putting persons at risk.
• Full protection against accidental contact must be ensured on
installation.
• Attention! Incorrect connection may result in the power
electronics unit being destroyed.
Power supply
Mains voltage: 400-415V 2N~, 50-60 Hz
Component rated voltage: 230 - 240V
Electrical connections

Technical data

EKI 607
Dimensions
Hob Height/ Width/ Depth
Cooking zone
Front left Ø cm / kW
Back left Ø cm / kW
Back right Ø cm / kW
Front right Ø cm / kW
Hob, total
* Power when the power boost function is activated
EKI 807
Dimensions
Hob Height/ Width/ Depth
Cooking zone
Front left Ø cm / kW
Back left Ø cm / kW
Back right Ø cm / kW
Front right Ø cm / kW
Hob, total
* Power when the power boost function is activated
EKI 848
Dimensions
Hob Height/ Width/ Depth
Cooking zone
Front left Ø cm / kW
Back left Ø cm / kW
Back right Ø cm / kW
Front right Ø cm / kW
Hob, total
* Power when the power boost function is activated

Start of operation

Once the hob has been installed and the power supply has been
provided (mains connected) an automatic test of the controls will
be carried out and information for Customer Service will be
indicated.
Briefly wipe over the surface of the hob with a sponge and soapy
water and then dry with a clean cloth.
GB
mm 45 x 589 x 519
21/ 2,3 (3,2)*
14.5/ 1.4 (1.8)*
18/ 1.85 (2,5)*
14.5/ 1.4 (1.8)*
kW 7.4
mm 45 x 779 x 519
26/ 2,4 (3,2)*
14.5/ 1.4 (1.8)*
18/ 1.85 (2.5)*
18/ 1.85 (2.5)*
kW 7.4
mm 45 x 779 x 519
26/ 2.4 (3.2)*
14.5/ 1.4 (1.8)*
18/ 1.85 (2.5)*
18/ 1.85 (2.5)*
kW 7.4
33