Uline H-2563 Guia De Inicio Rapido página 2

Figure 2
Figure 3
Figure 4
PAGE 2 OF 6
ASSEMBLY CONTINUED
5. Align the middle pre-drilled holes of tabletop boards
to the table top support (different angle). Attach 3⁄"
lag screws and washers using the power drill and
7/16" socket bit. (See Figure 2)
6. Place the three tabletop boards on the A-Frame
bases. Align the pre-drilled holes with the A-Frame
base. Loosely attach tabletop board slats to
A-Frame base with the 3⁄" lag screws and washers
using the power drill and 7/16" socket bit (will tighten
later in step 8). (See Figure 3)
7. Loosely drill the two tabletop supports (equal
angles) to the underside of the A-Frame table with
the tabletop support (different angle) in the middle
using 3" deck screws (will tighten later in step 8).
(See Figure 4)
8. Make sure the table is square and tighten all lag
and deck screws.
1-800-295-5510
uline.com
NOTE: H-6681 Mounting hardware sold
separately.
0721 IH-2563