Proper Entertainment Center Care And Cleaning; Cleaning And Maintenance; Defrosting; Power Interruptions - Haier HBCN05FVS Manual Del Usuario

English
Proper Entertainment Center Care & Cleaning

Cleaning and Maintenance

Warning: To avoid electric shock, always unplug your entertainment center
before cleaning. Ignoring this warning may result in death or injury.
Caution: Before using cleaning products, always read and follow
manufacturer's instructions and warnings to avoid personal injury or
product damage.
General: • Prepare a cleaning solution of 3-4 tablespoons of baking soda
mixed with warm water. Use sponge or soft cloth, dampened with
the cleaning solution, to wipe down your entertainment center.
• Rinse with clean warm water and dry with a soft cloth.
• Do not use harsh chemicals, abrasives, ammonia, chlorine bleach,
concentrated detergents, solvents or metal scouring pads. Some
of these chemicals may dissolve, damage and/or discolor your
entertainment center.
Door Gaskets: • Clean door gaskets every three months according to general
Defrosting Your Entertainment Center
Your entertainment center is designed with a manual defrost system. The
entertainment center surfaces will defrost, when the temperature control is turned
to 'Off". Water from the unit is disposed of automatically, by means of being
channeled onto a drip tray located on the compressor. Heat transfer from the
compressor causes this water to evaporate.

Power Interruptions

• Occasionally there may be power interruptions due to thunderstorms or other
causes. Remove the power cord from AC outlet when a power outage occurs.
When power has been restored, replug power cord to AC outlet.
Vacation and Moving Care
• For long vacations or absences, empty contents from entertainment center,
move the temperature DIAL to the OFF position and clean the entertainment
center and door gaskets according to "General cleaning" section. Prop
doors open, so air can circulate inside. When moving, always move the
entertainment center vertically. Do not move with the unit lying down. Possible
damage to the sealed system could occur.
7
instructions. Gaskets must be kept clean and pliable to assure
a proper seal.
• Petroleum jelly applied lightly on the hinge side of gaskets
will keep the gasket pliable and ensure a good seal.