Sony CDP-CX250 Manual De Instrucciones página 5

Hookups
When connecting the audio cord, be sure to match the
color-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player
LINE OUT
L
R
• If you have a Sony receiver (amplifier) equipped with
the CONTROL A1 jack
Be sure to connect the player to the CD IN jacks on the
receiver (amplifier). When making this connection, set the
COMMAND MODE of the player to CD1 (see the
illustration below). If you further connect the player and
the receiver (amplifier) via the CONTROL A1 jacks with the
CONTROL A1 cord (supplied for canadian models only),
you can use the Auto Function feature between these
components. For details, refer to the supplementary
"CONTROL-A1 Control System" instructions and the
instructions supplied with the receiver (amplifier).
• If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using an optical cable (not supplied). Take off the
cap and plug in the optical cable.
POC-15
Optical cable (not supplied)
CD player
DIGITAL OUT
OPTICAL
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software
other than music, such as a CD-ROM.
Amplifier
INPUT
CD
L
R
Digital component
DIGITAL INPUT
OPTICAL
When to use the COMMAND MODE selector
The COMMAND MODE selector is set to CD1 at the
factory for normal use. You can control this player by
connecting to a Sony CD Player with the player control
function, via the CONTROL A1 jacks. When making this
connection, set the COMMAND MODE selectors of each
player to the appropriate position according to the
connected line input jacks. For details, refer to the
instructions supplied with the connected player.
COMMAND MODE
CD
1 2 3
When using another Sony CD player together with
this player
You can make the supplied remote effective only for this
player.
• When using the player equipped with the
COMMAND MODE selector:
Set the COMMAND MODE selector of this player to
CD1 and that of another player to CD2 or CD3. Then
set the CD1/2/3 switch on the remote supplied for
each player accordingly.
• When using the player not equipped with the
COMMAND MODE selector:
The command mode of the player without the
COMMAND MODE selector is set to CD1. Set the
COMMAND MODE selector of this player to CD2, and
set the CD1/2/3 switch on the remote to CD2.
Setting the VOLTAGE SELECTOR (except for
European, Canadian and Singaporean
models)
Check that the VOLTAGE SELECTOR on the rear
panel of the player is set to the local power line
voltage. If not, set the selector to the correct position
using a screwdriver before connecting the AC power
cord to a wall outlet.
110 - 120 V
Getting Started Getting Started Playing CDs
220 - 240 V
5 EN