Standard Features; Manual Mode; Y-Single Slope Mode - Spectra Precision LL300S Guia Del Usuario

Standard Features

Manual mode

In horizontal mode pressing the Manual button on the laser or remote control once changes the laser from
automatic self-leveling mode to Manual mode. Manual mode is indicated by the flashing (once every second)
red LED e.
In Manual mode (horizontal), the Y-axis can be sloped by pressing the Up- and Down-Arrow-buttons on the laser
or remote control. Additionally, the X-axis can be sloped by pressing the Left- and Right-Arrow-buttons on the
remote control.
To resume automatic self-leveling mode, press the manual button twice.
In vertical mode, the laser is always in MANUAL mode. Pressing the up and down arrow buttons adjust the
slope of the laser beam. The left and right arrow buttons at the remote control can be used to align the laser
beam to the right/left side.
To resume automatic self-leveling mode, press the manual button again.

Y-Single Slope Mode

The Manual button on the laser and remote control toggles the unit to Manual, the Y-axis Single Slope Mode,
then Automatic Mode. To activate the Y-axis single slope mode, press the Manual button at the laser or remote
control twice. This is indicated by the simultaneously flashing red e and green d LEDs (once every second).
In Y-axis single slope mode, the Y-axis can be sloped by pressing the Up- and Down-Arrow-buttons on the laser
or remote control, while the X-axis remains in automatic self leveling mode (e.g. when setting up sloped ceilings
or drive ways).
To resume automatic self-leveling mode from Y-axis single slope mode, press the manual button again.
11