Tuning To Preset Stations; Presetting Radio Stations - Sony STR-SL50 Manual De Instrucciones

Preset tuning (continued)

Presetting radio stations

1
Press TUNER.
The last received station is tuned in.
2
Tune in the station that you want to
preset using Direct Tuning (page 24) or
Automatic Tuning (page 25).
3
Press MEMORY.
"MEMORY" appears in the display for a
few seconds.
Do steps 4 to 5 before "MEMORY" goes
out.
4
Press PRESET + or PRESET –
repeatedly to select a preset station
number.
Each time you press the button, the preset
station number changes in the
corresponding number and direction as
follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
If "MEMORY" goes out before you select
the preset station number, start again from
step 3.
5
Press MEMORY again to store the
station.
If "MEMORY" goes out before you can
store the station, start again from step 3.
6
Repeat steps 2 to 5 to preset another
station.
To change a preset number to
another station
Do steps 1 to 5 to preset a new station to the
number.
GB
26

Tuning to preset stations

You can tune the preset stations by either of the
following two ways.
Scanning the preset stations
1
Press TUNER.
The last received station is tuned in.
2
Press PRESET + or PRESET –
repeatedly to select the preset station
you want.
Each time you press the button, the receiver
tunes in one preset station at a time, in the
corresponding order and direction as
follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
Using the preset codes
1
Press TUNER.
The last received station is tuned in.
2
Press SHIFT to select a memory page
(A, B, or C), then press the preset
number of the station you want using
the numeric buttons.
Tip
You can also use PRESET TUNING +/– on the
receiver to tune to preset stations.