Grillfürst G201 Instrucciones De Uso / Instrucciones De Instalación página 23

d) Do not preheat longer then recommended.
e) Do not use a higher setting than required.
Connect the hose and regulator to the gas container at the right side of the gas grill. Keeping in mind
that the gas container must be kept away from heat and in a safe position. The hose dimension is 8mm
diameter.
5. Installation gas cylinder
After purchasing your gas cylinder you will then be ready to set it up with your gas grill.
a) When changing the gas bottle which shall be carried out away from any source of ignition.
Position the gas bottle at the side of your gas grill, not underneath, keeping in mind that the bottle
must be kept away from heat and in a safe position.
b) When ready to use your gas grill insert the regulator into the gas bottle valve and tighten firmly.
The maximum length of hose shall not exceed 1.5m.
Warning: Before attempting to light your gas grill you must refer to your lighting
instructions and warning / safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is found to
be faulty in any way do not attempt to use your gas grill.
When changing your gas bottle ensures that there are no sources of ignition close by i.e. fires,
cigarettes, naked flames etc. Make sure that the appliance is switched off.
Ensure that the hose is not subjected to twisting which will affect the gas flow when using your
gas grill. Also the hose must not have undue tension and must not touch any part of the gas grill which
may be hot.
flexible hose
Please choose
Every 2 years changing the flexible hose when the national conditions require it.
How to connect a gas bottle
a) Turn the orange cap so that the arrow is pointing to the gap in the shroud.
b) Remove the orange safety cap by pulling the lanyard out. Do not use tools. Leave the cap hanging.
c) Check that the black sealing washer is fitted inside the cylinder valve. Place the regulator down
over the valve with switch.
d) Turn the switch clockwise on gas bottle-then turn on the gas grill as instructed.
Warning: Always test gas line for leaks at connector with soap water finishing all
connections.
How to disconnect a gas bottle
a) Except for twin-cylinder installations with a changeover valve, turn off the gas tap if fitted to the
appliance. Wait until the burner and pilot light have gone out. For installations with a changeover
valve, it is only necessary to switch off the empty cylinder.
whose heatproof higher than 80℃
22
EN