Lighting Instructions - Grillfürst G201 Instrucciones De Uso / Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Rear - 600mm
Sides - 500mm
Top - 1000 mm
7. Safety precautions
a) Always test gas line for leaks at connector with soapy water after making connections.
b) The top lid must always be open when lighting the burner.
c) Use oven gloves and sturdy, long handled gas grill tools when cooking on the grill.
d) Be prepared if an accident or fire should occur. Know where the first aid kit and fire extinguishers
are and know how to use them.
e) Keep any electrical supply cord and the fuel supply hose away from any heated surfaces.
Always cook with great care.
f)

8. Lighting instructions

Caution: The lid must be open when lighting the burner!
Do not stand with your face directly over the gas grill when lighting it.
Your gas grill will have following method of ignition:
Pilot Gas Control Ignition:
With all gas controls on the Gas grill in the "AUS" position, turn the gas cylinder valve to the on
position at the regulator. To create a spark you must push the control knob in (A) and hold in this
position for 3-5 seconds to allow gas flow and then turn anticlockwise to" MAX" (B). It can spark to
the burner lighting tube (C). You will hear a "snap" from the igniter and you will also see a 3"-5"
orange flame coming from the burner lighting tube at the left side of the burner (D).
Continue to hold the burner control knob in for two seconds after the "snap", this will allow gas to
flow completely down the burner tube (E) and insure ignition.
When the burner is alight, adjacent burners will cross light when their controls are turned to "MAX"
At "MAX" setting the burner flame should be approximately 12-20mm long with a minimum of
orange flame. Turn the gas control fully anticlockwise for minimum setting.
Should you have any difficulty lighting your gas grill following the above steps, contact your dealer
for advice.
Warning : If the burner still does not light ,turn the burner control knob to" AUS" and
wait 5 minutes to let the gas clear before lighting again.
500mm
26
1000mm
600mm
500mm
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido