30398zsa_inst 7/11/06 14:07 Page 3
Adjust the collar to fit like a regular collar. You should be able to
easily pass two fingers between your dog's neck and the device (A).
We suggest that you check the collar regularly to make sure that it
is well adjusted.
Note: If these instructions are not properly followed, the buckle can
easily be pulled off the collar. This could lead to the device being lost
or damaged.
Your dog must get used to the device before you actually start using it. We suggest that
you make your dog wear the spray device during 4 to 5 days before inserting the battery
and filling the device. At the same time, we also suggest that you remove and put the
collar back frequently on your dog.
Filling the device
1. Set the device on a flat surface, with the fill-up valve turned
upwards. Shake the spray can before using it.
2. Hold the can upside down, then insert the aerosol tip in the
fill-up valve – the deepest cavity (A) – then press down firmly
for 10 seconds (B). Release pressure and press down for
another 10 seconds, then release.
Note: If spray is escaping as you attempt to fill the device,
increase the downward pressure on the refill can to get a better
seal. You cannot overfill the device. When completely filled, there
should be enough gas in your device for 18-23 sprays.
Inserting the battery
1. Slide off the battery cover from the spray device and insert one 6-volt alkaline
battery without forcing it, keeping the polarity in mind (+ and -) (A, B). Slide the cover
back on.
2. Slide off the battery cover from the remote control and insert one 6-volt
alkaline battery, respecting polarity (+ and -) (C, D). Slide the cover back on.
A
Using the Remote Control
• The upper button (no 1) emits a sound signal.
• The center button (no 2) sends a short spray.
• The lower button (no 3) sends a long spray.
Note:
Check if the device is working by pressing the upper
button (A) on your remote control; you should hear a beep.
(Black plate)
B
A
A
B
C
D
A