Fermax SLIM Manual De Usuario página 6

Cod. 97848 V09_18
By bringing the element close to the reading zone, the reader will send a signal to the connected decoder and the
pilot light will give a signal. The pilot light on the reader will flash until confirmation is received from the receiver.
The equipment is able to operate with four different communications protocols. Once the equipment is switched on,
the LED will indicate the protocol to be configured in the reader.
Protocol
AC+4420,MINI5276,IPAXES
(Wiegand 26)
AXESKEY (L-BUS)
Online Control unit (S-BUS)
Starting up
Installation
The reader consists of two elements: a compact box (1) with the front panel of plastic and the wiring output on the
rear panel, and a beauty sticker (2). It is designed for situate directly on the wall or embedded. The fixing is made by
means of two screws (3), separated 60 mm between them (ideal separation if you want to embed it in one standard
switching box). The sticker must be situated on the 2 position of the figure, assuring that the led (5) is visible across
the sticker window. Before situating the sticker, screw and configure the reader.
LED indications
Flashing red
1 / 2 / 3 or 4 red flashes corresponding to the channel
number configured
1 / 2 / 3 or 4 green flashes corresponding to the channel
number configured
6
3200284 REV01