Configuration - Fermax SLIM Manual De Usuario

Cod. 97848 V09_18
This reader can be installed into different types of surfaces, also into metallic surfaces, due to the automatic
adjustment of the frequency without the need of the installer intervention.
Connection
Connection is made through the wiring from the rear, which is connected directly to a AXESKEY (+, -, L) decoder or a
Wiegand (+, -, D0, D1, Control LED) or Online Control unit (S-BUS) (+, -, S-BUS).

Configuration

The proximity reader can be configured for work under Wiegand 26 or Online Control unit (S-BUS) or L-BUS protocol
(with channels 1, 2, 3 or 4).
Use the button (4) to configure the reader's operating mode.
WIEGAND 26 CONFIGURATION:
- Press the configuration button until the LED flashes red. Once the button has been released, the LED will remain lit
red. The LED in this operating mode is controlled by the control unit through the LED Control line.
The format will be 4 bit (zeros) + 20 bit code (maximum code value 1048575 AC+/65536 IPAXES).
Signal
+
-
L
D0 / S-BUS
D1
Control LED
Cable colour
red
black
blue
green
white
brown
7
3200284 REV01