Connecting To Vehicle Power; Cleaning And Care - Dometic MYFRIDGE MF1F Instrucciones De Uso

Cleaning and care

➤ If you want to cool drinks, connect the device to a power source and press the "Cold" button
(fig. 3 1, page 4).
✓ The operating display lights up and the device begins cooling.
➤ If you wish to end cooling, press the "Off" button (fig. 3 2, page 4).
➤ To switch off the device, pull out the connecting cable.
8.3 Heating drinks
A
NOTICE!
You must open the drinks bottle before heating. The drink expands as it heats and can
burst the bottle if it is not open.
➤ If you want to heat drinks, connect the device to a power source and press the "Heat" button
(fig. 3 3, page 4).
✓ The operating display lights up and the device begins heating.
✓ The device stops heating automatically when the drink has been heated to a temperature of
around 60 °C. This prevents the device from overheating.
It warms the drink again if the temperature falls.
➤ To end heating, press the "Off" button.
➤ To switch off the device, pull out the connecting cable.
8.4

Connecting to vehicle power

I
NOTE
If you connect the cooling device to the vehicle power, remember that you may have
to turn on the ignition to supply it with power.
9 Cleaning and care
!
WARNING! Electrocution hazard
Always disconnect the device from the power supply before you clean and service it.
A
NOTICE! Risk of damage
• Never clean the cooler under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can
damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and dirt, so that
heat can be released and the device is not damaged.
10
MF1F
EN