GYS GYSPACK PRO 800 Manual De Uso página 9

Operating manual
Connection / disconnection :
• Disconnect the power supply before plugging or unplugging
the connections to/from the battery.
• Always ensure the Red clamp is connected to the "+" battery
terminal first. If it is necessary to connect the black clamp
to the vehicle chassis, make sure it is a safe distance from
the battery and the fuel/exhaust pipe. The charger must be
connected to the power supply.
• After starting, disconnect the booster from the power supply,
then remove the frame connection and finally the battery
connection, in the order shown.
Connection:
• Class II device (for the charger).
• Class III device (for the GYSPACK 800).
• This device is equipped with a fuse protection
• The connection to the power supply must be carried out in
compliance with national standards.
Maintenance:
• If the power supply cable is damaged, it must only be replaced
by a cable specified or supplied by the manufacturer or its
after-sales service.
• Maintenance should only be carried out by a qualified person.
• Warning! Always disconnect from the mains before perform-
ing maintenance on the device.
• Do not use solvents or any agressive cleaning products.
• Clean the device's surfaces with a dry cloth.
Regulations:
• Equipment complies with European directives
• The compliance declaration is available on our website.
• EAEC Conformity marking (Eurasian Economic
Community).
• Material complies with British requirements. The UK
Declaration of Conformity is available on our website (see
cover page).
• Device consistent with Moroccan standards.
• The C‫( م‬CMIM) declaration of conformity is available on our
website.
Waste management::
• This product should be disposed of in an appropriate
recycling facility. Do not throw away in a household bin.
• This device's battery is recyclable. Please comply with the
the applicable waste management laws.
Translation of the original
instructions
GYSPACK PRO 800
9