Error Codes - LG WM9500H Manual Del Propietário

50 TROUBLESHOOTING

Error Codes

Problem
Water supply faucets are not
fully open.
Water line hoses are kinked,
pinched, or crushed.
Washer fills with
Water inlet filters are clogged.
water slowly
or not at all, or
Water supply pressure to
faucet or house is too low.
Water supply connected with
leaklimiting hoses.
If the balance is not
successful, this error will be
displayed.
The load is too small.
Heavy articles are mixed with
lighter items.
The load is out of balance.
All manuals and user guides at all-guides.com
Possible Cause
Make sure that the water faucets are fully open.
Make sure that the hoses are not kinked or pinched. Be
careful when moving the washer during cleaning and
maintenance.
Clean the inlet filters. See Maintenance in the Care and
Cleaning section.
Check another faucet in the house to make sure that
household water pressure is adequate and flow is not
restricted. Disconnect the inlet hose from the washer and
run a few gallons of water through the hose to flush the
water supply lines. If flow is too low, contact a plumber to
have the water lines repaired.
Hoses designed to limit leaks can trip falsely and prevent
the washer from filling. The use of leak limiting hoses is
not recommended.
The automatic attempt to rebalance the load was not
successful. The cycle has been paused to allow the load
to be manually adjusted.
Small loads may need additional items to be added to
allow the washer to balance the loads.
The load may have heavy items loaded with lighter
items. Always try to wash articles of somewhat similar
weight to allow the washer to evenly distribute the weight
of tghe load for spinning.
Manually redistribute the load if articles have become
tangled preventing the automatic distribution from
working properly.
Solutions