Error Codes - LG SIGNATURE WM9500HA Serie El Manual Del Propietario

Error Codes

Problem
Washer fills with
water slowly or not at
all, or
Possible Cause
Water supply faucets are not fully
open.
Water line hoses are kinked,
pinched, or crushed.
Water inlet filters are clogged.
Water supply pressure to faucet or
house is too low.
Water supply connected with
leaklimiting hoses.
If the balance is not successful,
this error will be displayed.
The load is too small.
Heavy articles are mixed with
lighter items.
The load is out of balance.
TROUBLESHOOTING
Solutions
• Make sure that the water faucets are fully open.
• Make sure that the hoses are not kinked or
pinched. Be careful when moving the washer
during cleaning and maintenance.
• Clean the inlet filters. See Maintenance in the
Care and Cleaning section.
• Check another faucet in the house to make sure
that household water pressure is adequate and
flow is not restricted. Disconnect the inlet hose
from the washer and run a few gallons of water
through the hose to flush the water supply lines.
If flow is too low, contact a plumber to have the
water lines repaired.
• Hoses designed to limit leaks can trip falsely and
prevent the washer from filling. The use of leak
limiting hoses is not recommended.
• The automatic attempt to rebalance the load was
not successful. The cycle has been paused to
allow the load to be manually adjusted.
• Small loads may need additional items to be
added to allow the washer to balance the loads.
• The load may have heavy items loaded with
lighter items. Always try to wash articles of
somewhat similar weight to allow the washer
to evenly distribute the weight of the load for
spinning.
• Manually redistribute the load if articles have
become tangled preventing the automatic
distribution from working properly.
49