Wear And Tear; Changing The Brakes; Changing The Wheel Spring - Micro Mini 3in1 Deluxe Plus Manual Del Usuario

Wear and tear

1. Put the seat pin
desired height (see Fig. J).
2. Secure the plastic covering
This approach is the same for both positions (high and low).
If you would like to remove the seat, follow these steps in the reverse order.
O-handlebar assembly is exactly the same as that of the T-handlebar (see chapter "Assembling the
handlebar"). Now: Have fun with the new vehicle!
Wear and tear

Changing the brakes

1. Unscrew the eight screws
2. Remove the deck
3. Replace the brake and screw the deck on again.

Changing the wheel spring

1. Loosen the screw
2. Push the wheel spring
3. Put the screw back and tighten it.
24
into the corresponding hole in the O-handlebar
9
with the hexagonal bolt
11
(see Fig. E).
5
(see Fig. F) and unscrew the brake screws with a screwdriver.
6
with a screwdriver (see Fig. G).
7
upwards and replace it with a new wheel spring (see Fig. H).
8
depending on the
10
.
12