WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
Electric igniters automatically light the surface burners when
control knobs are turned to IGNITE.
Before setting a control knob, place filled cookware on the
grate. Do not operate a burner using empty cookware or
without cookware on the grate.
To Set:
1. Push in and turn knob counterclockwise to IGNITE.
IMPORTANT: All 4 surface burners will click. Only the burner
with the control knob turned to IGNITE will produce a flame.
2. Turn knob to anywhere between Hi and Lo.
REMEMBER: When range is in use or (on some models)
during the Self-Cleaning cycle, the entire cooktop area may
become hot.
IMPORTANT: When cooktop is in use, the Self-Cleaning cycle will
be disabled. An error tone will sound and the Cooktop On indicator
light will flash. If you turn on the cooktop when the Self-Cleaning
cycle is in use, it will disable the Self-Cleaning cycle and "END" will
be displayed.
Power Failure
In case of prolonged power failure, the surface burners can
be lit manually. Hold a lit match near a burner and turn knob
counterclockwise to IGNITE. After the burner lights, turn knob
to setting.
6
COOKTOP USE
IMPORTANT: Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Burner cap: Always keep the burner cap in place when using a
surface burner. A clean burner cap will help avoid poor ignition and
uneven flames. Always clean the burner cap after a spillover and
routinely remove and clean the caps according to the "General
Cleaning" section.
Gas tube opening: Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents, or any other
material to enter the gas tube opening. Keep spillovers out of the
gas tube by always using a burner cap.
Burner ports: Check burner flames occasionally for proper size
and shape as shown in the previous illustration. A good flame
is blue in color, not yellow. Keep this area free of soil and do not
allow spills, food, cleaning agents, or any other material to enter
the burner ports.
To Clean:
IMPORTANT: Before cleaning, make sure all controls are OFF and
the oven and cooktop are cool. Do not use oven cleaners, bleach,
or rust removers.
1. Remove the burner cap from the burner base and clean
according to the "General Cleaning" section.
2. Clean the gas tube opening with a damp cloth.
Sealed Surface Burners
A
B
C
A. Burner cap
D. Igniter
B. Burner base
E. Gas tube opening
C. Alignment pins
A
B
A. 1-1
/
" (2.5-3.8 cm)
1
2
B. Burner ports
D
E