User Interface - ENERGY SISTEM TV1070/90 Manual Del Usuario

3.2. BATTERy
Pull the battery loader out and insert a CR2025 battery.
1
4. BUILT-IN RECHARGEABLE BATTERy (2070/2090 MODELS ONLy)
This portable TV uses a smart battery management system with low-battery detection.
≥
If the battery voltage falls below a specific value, the unit will enter low battery mode displaying a
flashing low battery icon in the OSD, indicating the user needs to recharge the TV immediately.
≥
If the AC/DC adapter is connected the battery will be charged whatever the power switch is on or
off.
≥
When the battery is almost exhausted a blinking empty battery icon will be displayed on the left-
up corner. The screen and audio will be disabled but the system is still working. If the user plugs
the DC adaptor soon enough the system will resume playback.
5. USER INTERFACE
Note that the first time you use EnergyTV it will automaticaly show the Setup->Installation screen in
order to scan for TV and radio channels. Please refer to Setup->Installation in page 8.
Once the channel scan is finished and all the channels are stored into the database, you can start to
watch the digital terrestrial TV channel or listen to the radio broadcast, some typical operations are
given in this chapter.
Press <Menu> to enter Main Menu. See Figure 1.
Press <Info> to display EnergyTV version information.
Make sure to place the battery in the correct direction.
When not using the remote control for a long time remove the
2
battery.
When operating range reduces replace the battery.
7