Care And Maintenance; Transport And Storage - Hilti DD-WMS 100 Manual De Usuario

3. Remove the filter bag. → page 13
4. Empty the waste material container.
5. Clean the water and waste material container.
6. Insert the filter bag. → page 11
7. Fit the top section of the appliance onto the waste material container.
8. Close the two catches.
7

Care and maintenance

7.1 Checking the prefilter
1. Remove the filter bag holder.
2. Check whether the prefilter is clogged.
3. If the prefilter is clogged, clean it with fresh water.
Alternatively, a brush or compressed air can be used to clean the
prefilter.
7.2 Checking the float level
CAUTION
Risk of damage to the equipment or other property! Incorrect operation
may lead to damage to the tool.
▶ Check and clean the water level monitoring system at regular intervals.
Switch the product off immediately if signs of damage are found.
1. Remove the filter bag holder.
2. Check that the float is free to move.
3. Clean the float if it does not move freely.
7.3 Checking the seal on the filter support
1. Check that the seal on the filter support is clean.
2. If the seal on the top section is dirty, clean it with a cloth.
3. Grease the seal.
8

Transport and storage

8.1 Stacking toolboxes for transport
1. Raise the toolbox retaining bar.
2. Stack the toolboxes with their grips placed over the toolbox retaining bar.
The toolbox retaining bar must project beyond topmost toolbox.
The maximum permissible additional load is 25 kg.
3. Attach the ratchet strap to the ratchet strap hook.
4. Use the ratchet strap to secure the toolboxes and prevent them slipping
out of place.
14 English
6
7
9
2154324
8
*2154324*