Eureka 430 Serie Guia Del Propietario página 12

●
U
62396
DCF-10
12
All manuals and user guides at all-guides.com
● ●
U T
●
V
FIG. 14
●
V
●
X
FIG. 15
62731
DCF-14
FIG. 16
ENGLISH
HOW TO MAINTAIN
(continued)
Remove a Clog in the Base
Step 3: Locate and remove clog from the power nozzle
you may remove the power nozzle from the main body of the
cleaner to locate the clog in the neck of the power nozzle.
Step 4: Reattach the clean-out port door
into position and rotating the door into the base until the latch
snaps into place. Ensure that the latch is secure. Do not use the
vacuum without first reattaching the clean-out port door.
CAUTION: Turn off the power switch and unplug the electrical cord
to service.
Brushroll Reset
This vacuum comes equipped with a brushroll circuit protector which turns
●
R
the brushroll off in the event of a stall situation. The check brushroll
●
T
light will turn on when the brushroll stalls. The circuit protector can be
reset by following the procedure described below.
Step 1: Turn off the vacuum and unplug it.
Step 2: Remove the obstruction from the brushroll
Step 3: Plug the cleaner back in and turn the vacuum on to continue
cleaning.
Step 4: For optimal performance periodically remove hair and threads
●
R
from the brushroll .
Clean Dust Cup Filter
CAUTION: Turn off the power switch and unplug the electrical cord
to service.
●
V
Clean dust cup filter as necessary.
●
F
Step 1: Remove dust cup .
●
Step 2: Remove dust cup lid
Step 3: Shake and brush the dust and dirt from filter. If desired, launder
the filter by hand in warm water using a mild detergent. The filter
may be washed up to 6 times. Air dry thoroughly before replacing
in cleaner.
Note: The dust cup filter is not dishwasher safe. Do not put in
dishwasher.
●
V
Step 4: To remove filter from dust cup lid
●
X and lift the filter out (FIG. 15).
●
V
Step 5: Replace filter in dust cup lid
duct cup lid and rotating release tab into the locked position.
●
Step 6: Replace dust cup lid U
the lid on the dust cup and twisting the lid firmly in place.
Step 7: Place bottom of dust cup
cup back into place until it locks.
You may order replacement filters from Electrolux Home Care
Products N.A., Service Division, P. O. Box 3900, Peoria, Illinois 61612.
Order dust cup filter, Style DCF-10, PN 62396 or HEPA filter, Style
DCF-14, PN 62731 (FIG. 16). To place an order please telephone
1-800-282-2886 or visit www.eureka.com.
(continued)
●
G
. If needed,
●
Q
by inserting the front edge
●
R
.
●
U and filter assembly V (FIG. 14).
●
U
press the release tab
●
U
by inserting filter frame tab in
● ●
and filter V in dust cup F
●
F
in main housing. Push top of dust
by placing