Power Switch - Eureka 430 Serie Guia Del Propietario

●
D
●
G
●
W
●
D
●
W
8
FIG. 6
All manuals and user guides at all-guides.com
●
A
●
C
●
N
FIG. 4
●
M
FIG. 5
●
L
FIG. 7
ENGLISH
HOW TO ASSEMBLE
CAUTION: Do not plug in cleaner until you understand all controls
and features.
Assemble completely before using.
Step 1: Attaching or Removing Floor Nozzle.
●
Align the lock button
hole in the receiving tube on the main body. Push the lock button
and slide the floor nozzle into the main body until it clicks into
place. Push the lock button in and pull on the floor nozzle to
remove it from the main body (FIG. 4).
●
A
Step 2: Attach Handle Grip
With the cord hook facing the rear of the cleaner, slide the handle
into place over the plastic adaptor (FIG. 4).
Step 3: Attach Hose and Hose Holder.
With the smaller side of the hose holder facing the front of the
cleaner, insert into guide channels and snap into place (FIG. 4).
●
W
Insert the hose end
●
M
coupling and twist counter clockwise to lock (FIG. 5).
Step 4: Store Cord (using cord hooks).
Pull the electrical cord down around the lower cord hook, then
wrap cord around upper and lower cord hooks
to electrical cord to prevent unwinding. (see page 6)
Step 5: Store Unit.
Push the telescoping handle release button
handle into its compact storage position. The handle is locked
down when a click is heard. (see page 6)
HOW TO USE

Power Switch

This vacuum has a 3-position switch
II is "Suction and Brushroll".
For bare floor cleaning use suction only (I). For carpet cleaning, use
suction and brushroll (II).
The nozzle allows for low profile cleaning. Airflow under the nozzle
automatically directs suction to the edges and corners for maximum full
width cleaning.
Hose and Attachments
CAUTION: Turn off the power switch and unplug the electrical cord
to service.
●
W
Step 1: Pull the hose end
unit and the hose holder
Step 2: Turn the hose actuator valve
from the floor nozzle to the hose end (FIG. 7).
Step 3: Attach hose wand, dusting brush, crevice tool or Power Paw™
(on some models only).
Step 4: After using attachments, remove hose wand, dusting brush,
crevice tool, or Power Paw™ (on some models only) and store in
designated holders.
Step 5: Turn the hose actuator valve
hose end to the floor nozzle.
Step 6: Wrap hose around the top hose holder
bottom of the unit into the hose retainer.
●
N on the floor nozzle G neck with the
.
with the guide tabs into the hose
●
I
. Fasten plug
●
J
to lower the
●
E
. O is Off, I is "Suction Only," and
from the hose retainer at the bottom of the
●
D
at the top (FIG. 6).
●
L
counter clockwise to direct air
●
L
clockwise to direct air from the
●
D and re-attach at the