Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
ADDITIONAL SAFETY RULES
FOR HAMMER DRILL/DRIVERS
1.
Apply forward force only on pistol grip handle and ONLY with your hands
when drilling.
2.
Do not use bits larger than those recommended. They may cause personal
injury due to jamming and loss of control. Large bits may also overload the
drill and damage the motor and gears.
3.
Verify that the mode selecting ring, the speed selector, and the reversing
switch are in correct positions for the operation being performed.
4.
Use only percussion-type carbide-tipped bits when hammer-drilling.
5.
Always wear ear protectors and safety glasses when hammer-drilling.
6.
Do not attempt to cut through reinforcing rods with percussion-type bits.
7.
Should the drill bit become jammed in the work, release switch trigger
immediately to prevent personal injury. Remove the battery from the tool and
remove the drill bit from the work. Do not attempt to free the stalled bit by
starting and stopping the motor. This could result in injury.
SAFETY INSTRUCTIONS FOR CHARGER AND BATTERIES
1.
SAVE THESE INSTRUCTIONS. This manual contains important safety and
operating instructions for Porter-Cable Battery Charger.
2.
Before using a battery charger, read all instructions and cautionary markings
on (1) battery charger, (2) battery pack, and (3) product using battery.
3.
be used to charge a Porter-Cable battery pack. Other types of batteries may
burst causing personal injury and damage. Do not charge a Porter-Cable
battery pack with any other charger.
4.
Do not expose charger to rain, snow or frost.
5.
Do not abuse cord. Never carry charger by cord or yank it to disconnect
from receptacle. Pull by plug rather than cord when disconnecting charger.
Have damaged or worn power cord and strain reliever replaced immediately.
DO NOT ATTEMPT TO REPAIR POWER CORD.
6.
Make sure cord is located so that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
7.
Do not use an extension cord unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock. If an extension
cord must be used, make sure:
A. That the pins on plug of extension cord are the same number, size and
shape as those of plug on charger.
B. That the extension cord is properly wired and in good electrical condition.
C. Wire Size of cord is at least as specified in following chart:
LENGTH OF CORD IN FEET
AWG SIZE OF CORD
D. If an extension cord is to be used outdoors it must be marked with
the suffix W-A or W following the cord type designation. For example
– SJTW-A to indicate it is acceptable for outdoor use.
8.
Do not operate charger with damaged cord or plug – have them replaced
immediately, to avoid a hazard. DO NOT ATTEMPT TO REPAIR POWER CORD.
9.
Do not operate charger if it has received a sharp blow, been dropped, or
otherwise damaged in any way; take it to a qualified serviceman.
To reduce risk of injury, a Porter-Cable charger should only
7
25
50
100
18
18
18
150
16
Publicidad
Tabla de contenido
