WAGNER 905 Power Steamer Manual Del Propietário página 7

Storage
When you have completed your steaming job, folow the steps below to store the unit.
1. Shut the unit OFF (O).
2. Activate trigger untill all pressure has been released.
3. Unplug power cord.
4. Allow steamer to cool for at least twenty (20) minutes.
5. Remove all accessories from trigger mechanism.
6. Empty any remaining water in reservoir to prevent overfilling the next time the steamer is used.
7. Place the unit in a cool, dry location.
Maintenance
Over time, the reservoir may experience mineral build-up caused by the high mineral content found in most local water
supplies. One way to avoid this is to use distilled water with this steamer. If you are unable to use distilled water,
follow the steps below to remove mineral build-up. It is recommended that these steps be performed on a periodic
basis.
1. Follow steps 1-6 in Storage, above.
2. Using the measuring cup, mix 8 ounces of vinegar and 8 ounces of water.
3. Slowly pour water/vinegar mixture into the reservoir.
4. Allow the unit to sit for at least thirty (30) minutes.
5. Empty the reservoir of the water/vinegar mixture.
6. Rinse reservoir with fresh water and drain. Repeat until vinegar odor dissipates.
7. Replace fill cap and store unit in a cool, dry place.
7 English