Uline H -7191 Manual De Instrucciones página 2

3. Insert edge protector into slot with handle up.
Firmly press handle down to cut to desired length.
(See Figure 3)
Figure 3
NOTE: You may use the newly cut edge protector
as a template to cut necessary length for
additional protectors. (See Figure 4)
Figure 4
1. Replace dull blades to ensure best cut quality.
2. Clean tool with brush and periodically use clean,
compressed air to blow dust off of unit.
PAGE 2 OF 15
OPERATION CONTINUED
4. When done cutting, press the handle down and insert
5. Insertion of safety pin locks movement of handle.
Last Edge
Protector
MAINTENANCE
3. Regularly apply light machine oil to all moving parts.
safety pin to lock handle movement. (See Figures 5-6)
NOTE: Ensure pin protrudes through back side of
cutter. This indicates pin is fully inserted.
Figure 5
Figure 6
Safety Pin
NOTE: With unit locked, you may carry cutter by
handle.
NOTE: For safety reasons, always lock handle
when not in use.
Figure 7
Safety Pin
0421 IH-7191