Uline H -7191 Manual De Instrucciones página 4

7. Put cutter blocks back. Fasten two screws and
washers. Repeat previous steps for blade on
opposite side. (See Figure 14)
Figure 14
WARNING! Not following instructions may cause
injury to user.
1. Loosen screws. Remove protective shields on both
sides. (See Figure 16)
Figure 16
2. Lift handle approximately 60° up to allow insertion of
safety pin into hole. (See Figure 17)
Figure 17
PAGE 4 OF 15
BLADE REPLACEMENT CONTINUED
Cutter Block
CUTTING BOARD REPLACEMENT
Safety Pin
8. Press handle down, and while at this position, pull
safety pin out. Place safety pin into pin holder.
Replace protective shield as shown. Tighten four
screws. Cutter is ready for use. (See Figure 15)
Figure 15
3. After insertion of pin, confirm safety pin protrudes
through other side. (See Figure 18)
NOTE: The safety pin now blocks the movement
of handle.
Figure 18
4. Unscrew bolts, nuts, block plates and fixed plate.
(See Figure 18)
0421 IH-7191