Blade Replacement - Uline H -7191 Manual De Instrucciones

WARNING! Not following instructions may cause
injury to user.
1. Remove four screws and pull protective shield out.
(See Figure 8)
Figure 8
2. Lift handle approximately 60° up to allow insertion of
safety pin into hole. (See Figure 9)
Figure 9
3. After insertion of pin, confirm safety pin protrudes
through other side. (See Figure 10)
NOTE: The safety pin now blocks the movement
of handle.
Figure 10
PAGE 3 OF 15

BLADE REPLACEMENT

Safety Pin
4. Put tool down to horizontal position. Use Allen wrench
to free screws and washers. Remove two cutter
blocks. (See Figure 11)
Figure 11
5. For safety reasons, use included magnet to hold
new blade. (See Figure 12)
Figure 12
6. Using magnet, place blade against pins as shown.
(See Figure 13)
Figure 13
Cutter Block
Pin
0421 IH-7191