G20010; Operating The Unit; Safety Block - TREVIDEA g3ferrari REALMIX Manual Del Usuario

rest. Never leave the appliance unattended while it is
running.
When mincing fruits, remove the pit and/or any tough
rind. Unplug the appliance from the electrical outlet
immediately after using and / or before touching any
accessory, especially the blades. If some food stops the
blades before removing it, unplug the unit from the
electrical outlet.
Do not insert food if it's too hot (maximum 40 C).
Not exceed the maximum capacity for ingredients as
indicated in the Operating section.
At the end of processing, wait for the blade to completely
stops before removing the food from the glass container.
When finished using the unit, it is advisable to wrap the
power cord so as to ensure a better cleaning, avoiding any
risk of damage.
For cleaning, we recommend using warm water only,
limiting the use of detergents. In this case, rinse the part
profusely. Do not immerse the motor unit in water or
other liquids; clean it with a damp cloth.
Caution: blades are very sharp; pay attention not to cut
yourself while removing the attachment or during
cleaning operations.
DESCRIPTION G20010
1. Main body
4. Transparent container

OPERATING THE UNIT

Assembling the unit by following the steps as shown besides.
1) Fit the glass container properly into the main body by turning
it into place until it snaps.
2) Insert the rostrum in the container without touching the blades.
3) Insert the food without exceeding the maximum capacity.
4) Fit lid properly over the container, by turning counterclockwise until it clicks in position.
5) Plug the unit and push the operation button to turn it on.

SAFETY BLOCK

This model has a double safety device: the unit only works if the container (4) is placed correctly into the
main body (7) and the lid (5) is correctly inserted in the joint. Remove the lid and the motor stops running.
2. ON/OFF button Container slot
5. Lid with safety block
3. Shaft
6. Rostrum with blades
10