sunjoe GTS4000E Manual Del Operador página 22

m
WARNING!
Pay attention to the winding direction.
NOTE: Always replace the spool with a new pre-wound spool.
Visit sunjoe.com to purchase the pre-wound spool (model
GTS4000E-RS-6PK) for this electric grass trimmer.
IMPORTANT: Keep all areas of the cutting head and cutting
head cover clean. Place the cap back by pushing it firmly
onto the cutting head. To ensure that the cutting head cover
is correctly fitted, try to remove it without depressing the two
latches. If it is correctly fitted, it should not move.
Troubleshooting
Problems Possible Cause
The motor does not
run or the tool runs
slowly.
Auto line feed does
not work.
Line fails to cut off.
• Power failure/unit not plugged
into a working receptacle.
• Spool housing cannot rotate freely.
• Cutting line does not protrude.
• Trimming blade bound with
accumulated grass.
• Auto feed out of line.
• Spool bound up.
• Auto feed is dirty.
• Spool line twisted when refilled.
• Not enough line is exposed.
• Line cutter in guard is covered,
damaged, or missing.
• Line extends past guard.
Storage
Follow these recommendations for storing the trimmer.
• Clean the grass trimmer thoroughly before storing.
• Store the grass trimmer in a stable and safe position out of
the reach of children. Keep the trimmer in a dry place where
the temperature is not too hot or too cold.
• When storing the grass trimmer, do not rest it against the
floor. Hang it by the upper handgrip so that the guard does
not touch anything. If the guard rests against a surface,
its shape and dimensions could be permanently altered,
and could render the machine unsafe to use.
Possible Solution
• Check to make sure the unit is plugged into a working
outlet. Make sure the extension cord is not damaged.
• Remove the spool and clean the slots; carefully remove
any grass and weeds or other debris.
• Cut the spool line off so that it just reaches the line
trimming blade.
• Take the trimmer to an authorized service center if the
trimmer does not start after completing these checks.
• Stop the machine and clean the trimming blade.
• Install a new spool of cutting line.
• Clean the auto feed.
• Remove the spool cover and pull the cutting line until it
reaches the trimming blade.
• Contact your authorized Snow Joe
or call Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
• Rewind or trim line to line cutter.
22
+ Sun Joe dealer
® ®
customer service center at
®