sunjoe GTS4000E Manual Del Operador página 23

Garden Tiller
Assembly
m
WARNING!
Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
Handle Assembly
1. Clamp the auxiliary handle with the telescoping pole using
the 4 screws, as shown (Fig. 52).
Fig. 52
Auxiliary
handle
Screws
Clamp
Telescoping pole
Fitting the Garden Tiller
1. Insert the telescoping pole into the tiller head. Press down
on the quick-release button to lock into position (Fig. 53).
Fig. 53
Quick-release
button
Auxiliary
handle
Clamp
Telescoping pole
Tiller head
23
2. Insert the rear handle into the end of the telescoping
handle (Fig. 54).
3. Press down on the quick release button. Ensure the
release button snaps firmly into position to lock the handle
securely.
Fig. 54
Quick release button
Rear
handle
Garden tiller with
telescoping pole
assembly
4. To remove, disconnect rear handle and tiller head from
ends of telescoping pole by lifting the quick release button
and pulling straight out.
Adjusting Tiller Angle
1. Adjust the garden tiller angles by depressing the adjusting
button (Fig. 55).
2. Turn the garden tiller head to a desired angle (Fig. 55).
3. The recommended tilling angles are between 0 and 40
degrees (Fig. 55).
Fig. 55
Adjusting
button
0º
40º
20º
Tiller
head