Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USING
Inserting the Batteries
Pull the battery compartment cap off the unit and pull out the battery protection strap.
The strap protects the batteries from being discharged. Slide the protection cap back
in place until the cap fits into the housing.
If the battery icon (B) appears, open the battery compartment cap and replace the
batteries as soon as possible with new ones of the same type and dimensions.
Insert the 4 batteries of the type LR44, observing right polarity.
1
Protection Cap
2
Measuring Probes
3
Display
4
ON / SET Button
5
Battery Compartment Cap
DISPLAY SYMBOLS
A
Display
B
Material Moisture Symbol
C
Battery Icon
D
Wood Moisture Symbol
E
Temperature Measuring Unit
F
Moisture Content in %
G
Display Backlight
Material Moisture
Selecting the Measuring Mode
Peel off the display protection foil before using the unit.
•
Hold the button ON/SET (4) pressed for 3 seconds. Now one of the 4 possible symbols (tree, wall,
°C, °F) is flashing. By pressing the button several times you will switch through the measuring
modes.
•
After selecting a measuring mode, the resp. symbol appears on the display and starts flashing.
Wait for approx. 4 seconds until the setting is stored and the measuring mode is activated.
•
Take off the protection cap of the measuring probes in order to undertake a measurement.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Wood Moisture
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Temperature °C
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Temperature °F
Publicidad
Tabla de contenido
