Extension Cords - SKI 8120 Instrucciones De Funcionamiento

SM 2609003411 03-09:SM 2609003411 03-09 3/9/09 9:46 AM Page 10
Service
NO USER SERVICEABLE
W RNING
PARTS INSIDE. Preventive
maintenance performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could cause serious hazard. We recom-
mend that all tool service be performed by a
Skil Factory Service Center or Authorized
Skil Service Station. SERVICEMEN:
Disconnect tool and/or charger from power
source before servicing.
BATTERIES
Be alert for units that are nearing their
end of life. If you notice decreased tool
performance or significantly shorter running
time between charges then it is time to
replace the unit. Failure to do so can cause
the tool to operate improperly or damage the
charger.
If an extension cord is
W RNING
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
All manuals and user guides at all-guides.com
Maintenance
charger from the power supply before
cleaning. The tool may be cleaned most
effectively with compressed dry air. Always
wear safety goggles when cleaning tools
with compressed air.
parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that
contain ammonia.

Extension Cords

RECOMMENDED SIZES OF ExTENSION CORDS
Ampere
-10-
Cleaning
To avoid accidents, always
W RNING
disconnect the tool and/or
Certain cleaning agents and
C UTION
solvents damage plastic
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Cord Length in Feet
Rating
25 50 100 150
3-6 18 16 16 14
6-8
18 16 14 12
8-10 18 16 14 12
10-12
16 16 14 12
12-16 14 12 — —
2
Wire Sizes in mm
Cord Length in Meters
15 30 60 120
0.75 0.75 1.5 2.5
0.75 1.0 2.5 4.0
0.75 1.0 2.5 4.0
1.0 2.5 4.0 —
— — — —