Changing Blades - SKI 8120 Instrucciones De Funcionamiento

SM 2609003411 03-09:SM 2609003411 03-09 3/9/09 9:46 AM Page 7
Wear gloves and place
W RNING
protective guard on the
blade before removing or installing the
blade.
REMOVING THE BLADE
1. Push the blade cover release button and
slide cover toward On/Off switch (Fig. 2).
2. Lift the blade cover in direction of arrow and
remove from the housing (Fig. 3).
FIG. 2
ON/OFF
SWITCH
BL DE
COVER
BL DE COVER
RELE SE BUTTON
Wear gloves and place
W RNING
protective guard on the
blade before removing or installing the
blade.
INSTALLING THE BLADE
1. Position blade as shown, while aligning
holes in blade with drive pins and push blade
onto drive pins in direction of arrow (Fig. 5).
Note: If the appliance appears to have no
grease in the gears, add a small amount of
general purpose grease such as MOBILUX EP-2.
FIG. 5
BL DE
DRIVE
PINS
All manuals and user guides at all-guides.com
Assembly

CHANGING BLADES

3. Lift the blade in direction of arrow and
cover is properly attached. The blade could
unexpectedly detach if the cover is not properly
attached.
FIG. 3
BL DE
COVER
Note: When attaching the blade cover ensure
that all four locating tabs are inside the housing
before sliding blade cover into place (Fig. 6).
2. Slide the blade cover toward the blade to
secure (Fig. 7).
cover is properly attached. The blade could
unexpectedly detach if the cover is not properly
attached.
FIG. 6
BL DE
COVER
-7-
remove (Fig. 4).
Do not attempt to operate
W RNING
the appliance unless the
G
FIG. 4
BL DE
Do not attempt to operate
W RNING
the appliance unless the
FIG. 7
BL DE
BL DE
COVER