SKI 8120 Instrucciones De Funcionamiento página 8

SM 2609003411 03-09:SM 2609003411 03-09 3/9/09 9:46 AM Page 8
INTENDED USE
The product is intended for light trimming of
shrubs and lawn edges in domestic use.
SAFETY SWITCH
The safety switch is designed to prevent
accidental starts. To operate safety switch,
press the release button with your thumb on
either side of handle to disengage the lock,
then pull the trigger (Fig. 1). When the trigger
is released the button will engage the safety
switch automatically, and the trigger will no
longer operate.
CUTTING WITH YOUR SHEAR
Hold the shear away from yourself. Stand in a
secure and stable position.
SHRUB SHEAR
Cutting hedges: Before cutting check the
hedge for foreign objects e. g. wire fences.
Cut stems up to 8 mm in thickness. When
cutting, move steadily along the line of cut, so
1. The charger was designed to fast charge
the battery only when the battery temperature
is between 32˚F (0˚C) and 113˚F (45˚C). If the
unit is too hot or too cold, the charger will not
fast charge the battery. (This may happen if
the unit is hot from heavy use). When the
battery temperature returns to between 32˚F
(0˚C) and 113˚F (45˚C), the charger will
automatically begin charging.
2. A substantial drop in operating time per
charge may mean that the unit is nearing the
end of its life and should be replaced.
3. Remember to unplug charger during storage
period.
4. If battery does not charge properly:
All manuals and user guides at all-guides.com
Operating Instructions
that stems are fed directly into the cutter
blades. The double edge of the cutting blade
enables you to cut in either direction, or with a
side to side motion.
After use replace the blade protector.
• Cut shrubs with deciduous leaves in June
and October.
• Cut evergreen shrubs in April and August.
• Cut conifer and other fast growing shrubs
approx. every six weeks from May onwards.
Edging: Guide the shear along the edge of
the lawn. Do not allow the blade to contact
paved surfaces, stones or garden walls, this
will wear the blade rapidly.
IMPORTANT CHARGING NOTES
some other electrical device.
light switch which turns power "off" when lights
are turned off.
cotton swab and alcohol if necessary.
take or send unit and charger to your local Skil
Service Center. See "Tools, Electric" in the
Yellow Pages for names and addresses.
Note: Use of chargers not sold by Skil will
void the warranty.
-8-
RECOMMENDED
CUTTING/TRIMMING TIMES
GRASS SHEAR
a. Check for voltage at outlet by plugging in
b. Check to see if outlet is connected to a
c. Check unit terminals for dirt. Clean with
d. If you still do not get proper charging,