Technical Data; End Of Life Disposal - ARAG 466970X0 Instalación Uso Y Mantenimiento

5 MAINTENANCE
In case of operation failure, ensure that the power supply harness is correctly connected (Fig. 2).
5.1 Troubleshooting
FAULT
The LED is ON, but the selected
operation has not been carried
out
The operations performed are
opposite to the selected ones or
incorrect
Electric valves work properly, but
pistons do not move
6

TECHNICAL DATA

Description
Power supply voltage
Max. switchable current for each output
Operating temperature
Storage temperature
Output protection through resettable fuse
Size
Weight
7

END OF LIFE DISPOSAL

Dispose of the system in compliance with the established legislation in the country of use.
CAUSE
The hydraulic control unit cable
connector is disconnected
Connectors are inverted on the electric
valves
The pilot valve is not connected
Hydraulic control box 4669
12 Vdc (Vmin 9 / Vmax 16)
3 A
-20 °C ÷ 55 °C / -4 °F ÷ +131 °F
-20 °C ÷ 55 °C / -4 °F ÷ +131 °F
•
144 x 108 x 110 (harness not included)
900 ÷ 924 g (according to the type)
10
REMEDY
• Check the connector.
• Ensure that connectors are
correctly connected to electric valves
(Fig. 4).
• Check pilot valve connection
(Fig. 4).
Tab. 1