Publicidad
Idiomas disponibles
Idiomas disponibles
TFA_No. 30.5011_Anleitung_10_21
COMFORT CONTROL – Thermo-Hygrometer
Duration of airing:
• A few minutes are mostly sufficient. Check the value indicated on your COMFORT CON-
TROL!
Operation:
Startup:
• Lightly push the silver battery lid on the front down and open the battery compartment.
Remove the battery safety strip. Close the battery compartment again.
• Remove the protective foil from the display. The unit is now ready to use.
Display:
• The left display shows the indoor relative humidity, the middle row the room temperature
and the right row the dew point. The temperature unit can be changed from °C to °F by
the °C/°F-button at the backside.
Humidity alarm:
• Select the humidity alarm value 65, 60 or 55 % by the sliding switch at the backside.
• If air humidity exceeds the selected value and there is a risk of mould formation, the up-
arrow and the red lamp will flash and an alarm signal will sound for 1 minute. The alarm
can be turned off by pressing any button.
• When air humidity falls below the selected value the up-arrow and the red lamp will stop
flashing. The up-arrow remains on the LCD showing that humidity exceeded the preset
value at least once in the past. Press any button and the up-arrow will disappear. The
acoustic signal can be muted by operating the sliding switch on the rear-side.
MIN / MAX temperatures:
• Press the MIN / MAX button and the highest temperature and humidity is displayed since
the last reset.
• Press the MIN / MAX button again, the display shows the lowest temperature and humid-
ity since the last reset.
• To go back to the present values, press the MIN / MAX button once more.
• Press the RESET button, while the maximum and minimum values are displayed to clear
the recorded maximum and minimum readings and the actual values appear.
Placing or hanging up the unit:
• A circular opening is provided on the backside of the unit for hanging on the wall. To
place the unit in the standing position use the stand supplied with the unit. Since the
humidity level within rooms can vary greatly according to the location, mount the unit so
that it will monitor the conditions in a location likely to be subject to the most problems.
Care and maintenance
• Clean your instrument with a soft damp cloth. Do not use solvents or scouring agents
• Remove the batteriesif you do not use it for a long period of time
• Keep the instrument in a dry place.
Battery replacement
• Remove the stand if necessary. Lightly push the silver battery lid on the front down and
open the battery compartment. Replace the batteries (2 x 1.5 V AA). Do not use
rechargeable batteries. Close the battery compartment again.
10
18.10.2021
16:23 Uhr
Seite 6
COMFORT CONTROL – Thermo-Hygrometer
Troubleshooting
Problems
Solution
➜ Observe correct polarity when inserting the batteries
No indication
➜ Change the batteries
➜ Change the batteries
Incorrect display
➜ Press the RESET button
If your device fails to work despite these measures contact the supplier from whom you
purchased it.
Waste disposal
This product and its packaging have been manufactured using high-grade materials and
components which can be recycled and reused. This reduces waste and protects the envi-
ronment.
Dispose of the packaging in an environmentally friendly manner using the collection sys-
tems that have been set up.
Disposal of the electrical device
Remove non-permanently installed batteries and rechargeable batteries from
the device and dispose of them separately.
This product is labelled in accordance with the EU Waste Electrical and Elec-
tronic Equipment Directive (WEEE).
Please do not dispose of this product in ordinary household waste. As a con-
sumer, you are required to take end-of-life devices to a designated collection
point for the disposal of electrical and electronic equipment, in order to ensure
environmentally-compatible disposal. Observe the current regulations in place!
Disposal of the batteries
Never dispose of empty batteries and rechargeable batteries with ordinary
household waste. They contain pollutants which, if improperly disposed of, can
harm the environment and human health. As a consumer, you are required by
law to take them to your retail store or to an appropriate collection site depend-
ing on national or local regulations in order to protect the environment.
The symbols for the contained heavy metals are:
Cd=cadmium, Hg=mercury, Pb=lead.
Specifications
Measuring range indoor
Temperature:
-10 °C... +60 °C (+14°...+140 °F)
Accuracy:
± 1°C
Humidity:
1 %rH ... 99 %rH
Accuracy:
±4% (35%...75%), otherwise ±5%
Power consumption:
2 x 1.5 V AA (batteries included)
Dimensions:
95 x 25 (65) x 95 (106)mm
Weight:
90 g (instrument only)
11
Publicidad
