DeWalt DW927 Manual Del Usuario página 24

E N G L I S H
After approx. 4 hours, it will switch to maintenance
charge mode. The battery pack can be removed at
any time or left in the connected charger indefinitely.
• The red charging indicator flashes rapidly to
indicate a charging problem. Reinsert the battery
pack or try a new one. If the new pack also
refuses to charge, have your charger tested by
an authorised D WALT repair agent.
E
• When plugged into power sources such as
generators or sources that convert DC to AC,
the red charging indicator may blink twice, switch
off and repeat. This indicates a temporary
problem of the power source. The charger will
automatically switch back to normal operation.
Do not charge the battery pack at
ambient temperatures < 4 °C or > 40 °C.
Recommended charging temperature:
approx. 24 °C.
Inserting and removing the battery pack
• Insert the battery pack into the grip (8) until it
clicks in place.
• To remove the battery pack, press the two
release buttons (10) simultaneously and pull the
pack out of the grip (8).
Equalisation mode
The equalisation mode helps to maintain the
optimum capacity of the battery pack. It is therefore
recommended to use the equalisation mode weekly
or every 10 charge/discharge cycles.
• Charge the battery pack as described above.
• When the charging indicator stops blinking, leave
the battery in the charger for approx. 4 hours.
DE9108/DE9116 - Hot Pack Delay
When the charger detects a battery that is hot,
it automatically starts a Hot Pack Delay, suspending
charging until the battery has cooled. After the
battery has cooled, the charger automatically
switches to the pack charging mode. This feature
ensures maximum battery life. The red indicator (12)
blinks long, then short while in the Hot Pack Delay
mode.
Inserting and removing bits (fig. A & B)
• Open the chuck by turning the sleeve (13)
counterclockwise and insert the bit shank.
24
All manuals and user guides at all-guides.com
• Place the bit in the chuck as far as it will go and
• Tighten firmly by turning the sleeve clockwise.
• To remove the bit, proceed in reverse order.
Selecting the operating mode or adjusting the
torque (fig. C)
The collar of this tool has 17 positions for the
adjustment of the torque to suit the size of the screw
and the workpiece material. For torque adjustment,
refer to the section «Screwdriving».
• Select the drilling mode or torque by aligning the
Forward/reverse slider (fig. D)
• To select forward or reverse rotation, use the
Two gear selector (fig. E)
Your tool is fitted with a two gear selector (3) to vary
the speed/torque ratio.
1 low speed/high torque
2 high speed/low torque
For speed rates, refer to the technical data.
• Do not change gears at full speed or during use.
Instructions for use
lift slightly before tightening.
symbol or number on the collar (4) with the
indicator (14) on the housing.
forward/reverse slider (2) as shown (see arrows
on tool).
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
(drilling large holes, driving screws)
(drilling smaller holes)
Always push the two gear selector
completely forward or backward.
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework and
wiring.
• Apply only a gentle pressure to the tool.