Insert Batteries - SEVERIN RB 7026 Instrucciones De Uso

Insert batteries:

∙ Two AAA batteries are required for the remote control. Two batteries are included in the delivery.
∙ Open the battery compartment at the back of the remote control. Insert two batteries. Make sure the polarity is correct.
∙ Close the battery compartment.
Using the remote control
∙ The remote control can only be used within 20 m of the appliance. Obstacles such as walls, cupboards, etc. may prevent
the signal from being transmitted.
∙ If the remote control does not work as described below,
∙ replace the batteries.
or
∙ the remote control and the appliance must be paired again:
1. Switch off the appliance completely by pressing and holding the
2. Press and hold the
pressed until the appliance switches on. The remote control and the appliance are now paired.
Symbol
Cleaning at the current location
Cleaning corners
Setting the time
(see note * below)
Setting the timer
(see note * below)
Charging the appliance
* Note: The remote control is set to 12-hr-mode. When setting the time and timer, observe AM (morning) and PM (afternoon)
indications!
Operating the appliance with the remote control
button on the appliance and the
Description
Start/Stop
Forward
Left
Right
Back
Turbo mode
button for approx. 3 seconds.
button on the remote control simultaneously. Keep them
Starts and stops the appliance.
The appliance moves forward as long as the button is pressed.
The appliance turns to the left as long as the button is pressed.
The appliance turns to the right as long as the button is pressed.
The appliance turns 180° and then moves forward.
The appliance cleans a radius of approx. 1.50 m around the current
location and then stops.
The appliance cleans the corners of the room and then returns to the
The appliance cleans in turbo mode until the button is pressed again or
until the appliance returns to the station.
To confirm, two acoustic signals sound when the function is switched on
and one acoustic signal sounds when the function is switched off.
In Turbo mode, the appliance cleans with high power, which can lead
to a shorter suction time and the appliance has to be recharged more
Press the button. The hour display flashes and the time can be set
using the buttons. Use the
minutes. Pressing the
To start the appliance at a specific time, the timer can be set as
described in Chapter "Setting the time".
Confirm the entered time by pressing the
appliance starts every day at the desired time.
The function is cancelled by pressing and holding the
The appliance is sent to the charging station for charging.
Function
charging station.
quickly.
buttons to switch to setting the
button again confirms the entry.
button again. The
seconds.
button for 3
21