Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the appliance
Clean the body of theappliance and the charging station with a dry cloth if necessary.
Sensors, brushes and control wheel must be cleaned regularly. A table with cleaning and replacement intervals is provided at
the end of this chapter.
Cleaning the anti-fall sensors
If the bottom of the appliance is very dirty, the anti-fall sensors must be cleaned.
1.
Make sure that the appliance is switched off .
2.
Turn the appliance over.
3.
Wipe all four anti-fall sensors with a clean, lint-free cloth.
Cleaning the brush roller
If the brush roller does not turn properly, it must be cleaned.
1.
Make sure that the appliance is switched off.
2.
Turn the appliance over.
3.
Squeeze the latch (
4.
Remove the brush roller .
5.
Remove any dirt from the brush roller . If necessary, carefully use tweezers and/or scissors.
6.
Vacuum the brush roller area if necessary.
7.
Replace the brush roller and the lock.
Cleaning the round brushes
If hair or lint is caught in the side brushes, clean them.
1.
Make sure that the appliance is switched off.
2.
Turn the appliance over.
3.
Unscrew the screws of the two side brushes and remove the brushes and the white felt rings.
4.
Remove any lint or hair.
5.
Gently wipe the brush hairs with a soft cloth.
6.
Allow the brushes to dry completely.
7.
Insert the white felt rings into the brush holder on the appliance.
8.
Screw the round brushes to the appliance. The round brush with hexagon (R) must be mounted on the right side of the
appliance (position of use!) and the round brush with square (L) on the left side of the appliance (position of use!).
Note:
If the round brushes are bent, unscrew the round brushes and place them for a few minutes in 80°C hot water. Allow to dry
thoroughly before reattaching.
Cleaning the front wheel
If hair or lint has become caught in the front wheel, it must be cleaned.
1.
Make sure that the appliance is switched off.
2.
Turn the appliance over.
3.
Remove any lint or hair (use tweezers, if necessary).
Component
Dust container
Filter
Brush roller
Round brushes
Front wheel
) on the brush roller cover and remove the cover.
Recommended cleaning and replacement intervals
Cleaning
Empty daily / clean weekly
Weekly
Weekly
Monthly
Monthly
Replacement
-
Every 6 months
Every 6 - 12 months
Every 3 - 6 months or as needed
-
23
Publicidad
Tabla de contenido
Solución de problemas
