Checking The Battery Charge Level; Inserting/Removing The Battery Pack; Fixing/Attaching The Shoulder Strap; Mounting The Motor Head On The Telescopic Handle - Parkside PTHSA 20-Li B3 Traducción Del Manual De Instrucciones Original

Checking the battery charge level

♦ Press the battery charge level button i to
check the status of the battery (see also main
diagram). The status will be shown on the
battery display LED u as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Inserting/removing the battery
pack
Inserting the battery pack
♦ Push the battery pack r into the handle until it
clicks into place.
Removing the battery pack
♦ Press the release button t and remove the
battery pack r.
WARNING! RISK OF INJURY!
► Before any work on the appliance, remove
the battery. Risk of electric shock!

Fixing/attaching the shoulder strap

♦ Hook the shoulder strap e into the carrying
lug 9.
♦ Adjust the length of the shoulder strap e to
your size so that the carrying lug 9 is at hip
height when the strap is hooked in place.
│ GB │ IE
■ 10
Mounting the motor head on the
telescopic handle
♦ Undo the quick release 7 by pressing it in
the direction of the arrow
telescopic handle until the black plastic ring
is exposed.
♦ Place the lower end of the motor head 3 on
the upper end of the telescopic handle 6 so
that the motor head 3 can be pushed through
as far as the black plastic ring. Make sure that
the groove and the recess interlock with each
other.
♦ Tighten the red connecting piece 5 by turning
it towards the symbol on the motor head 3.

Adjusting the telescopic handle

The telescopic handle 6 can be adjusted continu-
ously by means of the quick release 7.
♦ Undo the quick release 7 by pressing it in the
direction of the arrow
length by pushing or pulling as required.
♦ Close the quick release again 7 to fix the
desired working length of the telescopic
handle 6.
♦ If the screws on the quick-release 7 have loos-
ened, tighten them again with the hex key w.

Adjusting the cutting angle

NOTE
► The cutting angle can be adjusted in 11
stages.
♦ Remove the battery pack r from the appliance.
♦ Press the release button 4.
♦ Adjust the angle of the motor unit to the
required position.
♦ Let go of the release button 4 and the motor
unit will click into place.
♦ Insert the battery pack r back into the appli-
ance.
. Pull out the
and adjust the
PTHSA 20-Li B3