Tripp-Lite N785-H01-SCMM Guia De Inicio Rapido página 4

Installation
2
Connect the media converter to a second identical media converter
using the appropriate type of fiber cable, making sure to connect the
TX port on one unit to the RX port on the other.
Note: See the Product Features section in this manual to determine which
type of fiber cable is supported by your media converter.
3
Connect the RJ45 port on the second media converter to your
network device (workstation, hub, switch, etc.) using a Cat5e/6 cable.
Network
4
Connect the external power supplies that came with each media
converter, and plug them into an AC power source.
N785-H01-SFP
Notes:
• The following installation instructions refer to an installation in which two media
converters are used. A single media converter can be used for a copper-to-
fiber installation.
• The following installation instructions refer to the N785-H01-SFP. Connections
Power Source
are the same for all models, with only the specs being different. See the
Specifications section in this manual for details on your media converter.
• To avoid damage due to Electrostatic Discharge (ESD), it is recommended you
handle the product while wearing an ESD wrist grounding strap or by touching
a conductive surface (such as metal) to discharge any potential ESD prior to
handling the product.
Network
Network
1
Power Source
Power Source
1
Connect the RJ45 port on the media converter to your network with a
user-supplied Cat5e/6 cable.
2
Connect a transceiver to the open SFP port on the media converter.
3
5
4
Network Device
Power Source
Network Device
Network Device
4
5
Power Source
Power Source