Tripp-Lite N785-H01-SCMM Guia De Inicio Rapido página 5

Installation
3
Connect fiber cabling matching the transceiver type to the
transceiver's port and to a second media converter with a matching
transceiver.
4
Connect the RJ45 port on the second media converter to your
network device (workstation, hub, switch, etc.) using a Cat5e/6 cable.
5
Connect the external power supplies that came with each media
converter, and plug them into an AC power source.
LED Status Table
LED
PWR (Green)
PWR (Green)
ALM (Red)
ALM (Red)
RJ45
1000 (Green)
1000 (Green)
LNK/ACT (Green)
LNK/ACT (Green)
Fiber
1000 (Green)
1000 (Green)
LNK/ACT (Green)
LNK/ACT (Green)
Status Description
On The unit is powered on
Off The unit is not powered on
On LFS enabled and link fault occurred
Off LFS disabled or no link fault occurred
On Copper connection up to 1000 Mbps
Off Copper connection speed at 10/100
Mbps or connection failed
On Copper port correctly linked
Off Copper port link failure
On Fiber connection up to 1000 Mbps
Off Fiber connection speed at 10/100
Mbps or connection failed
On Fiber port correctly linked and data is
transmitting
Off Link failed, data is not transmitting
5