DJI ZENMUSE X9 Manual Del Usuario página 6

Disclaimer and Warning
Congratulations on purchasing your new DJI OSMO
practices provided by DJI OSMO before use. Failure to read and follow instructions and warnings may result in serious injury
to yourself or others, damage to your DJI OSMO product, or damage to other objects in the vicinity. By using this product,
you hereby signify that you have read this document carefully and that you understand and agree to abide by all terms and
conditions of this document and all relevant documents of this product. You agree to only use this product for proper purposes.
You agree that you are solely responsible for your own conduct while using this product and for any consequences thereof. DJI
OSMO accepts no liability for damage, injury, or any legal responsibility incurred directly or indirectly from the use of this product.
RONIN is a trademark of SZ DJI OSMO TECHNOLOGY CO., LTD. (abbreviated as "DJI OSMO") and its affiliated companies.
Names of products, brands, etc., appearing in this document are trademarks or registered trademarks of their respective
owner companies. This product and document are copyrighted by DJI OSMO with all rights reserved. No part of this product
or document shall be reproduced in any form without the prior written consent or authorization of DJI.
This document and all other collateral documents are subject to change at the sole discretion of DJI OSMO. This content is subject
to change without prior notice. For up-to-date product information, visit the product page for this product at http://www.dji.com.
Introduction
The DJI ZENMUSE TM X9 Focus Motor enables users to control the lens focus of the DJI X9 gimbal camera.
2
1
Installation
Attaching the Focus Gear Strip
Attach the provided gear strip to the camera lens to use the focus motor if the camera does not have a lens focus ring with a 0.8
module gear. Make sure to power off the gimbal camera before attaching.
Make sure the teeth of the gear strip are facing outward. Line
up the gear strip on the focus ring or the zoom ring on the
lens and pull it taut.
4
TM
3
7
4 56
product. Carefully read this entire document and all safe and lawful
1. Rod
2. Gear Lock Knob
3. Gear
4. Motor
5. Status LED
6. Power and Communication Port
7. Rod Lock Knob
Press the gear strip into the belt holder while holding it tightly.