DJI ZENMUSE X9 Manual Del Usuario página 8

• Make sure that the focus motor is attached securely.
• Make sure to balance the camera setup after attaching the focus motor.
• Make sure that the rod lock knob is attached securely before using each time.
• Make sure that the LiDAR range finder/focus motor cable is connected correctly and securely.
• Only use the provided LiDAR range finder/focus motor cable. Third-party cables are not supported.
Replacing the Rod
Loosen the gear lock knob and remove the rod lock knob.
Install the new rod.
The gear also contains smaller parts. Make sure they are not lost when removing the gear lock knob from the gear.
Specifications
Focus Motor
Weight (with default rod)
Dimensions
Max Torque
Max Speed
Operating Current
Operating Voltage
Focus Gear Strip
Adapted Lens
Diameter Range
6
110 g
89×69×28 mm
0.2 Nm
120 RPM
Free current: 50 mA (13.7 V)
Stall current: 1 A
13.7 V
30-110 mm
Remove the rod.
Tighten the gear lock knob and attach the rod lock knob.
Noise
Gear
Operating Temperature
Compatibility
Adapted Lens
Diameter Range
Gear Strip Length
≤40 dB(A) (0.1 m distance)
No. of teeth: 28, Module: 0.8
-10° to 40° C (14° to 104° F)
DJI Ronin 4D
40-90 mm
377 mm