Powering On The Microbrite Color Lights - Pentair MICROBRITE Guia Del Usuario

2
Operating MicroBrite™ Color LED Light using a Wall Switch
MicroBrite Color Lights can be controlled using a standard wall-mount light switch (or by
the Pentair Controller (sold separately), contact your dealer for more information. Multiple
MicroBrite color lights can be connected via a junction box and a 12 VAC transformer to a
single switch so that all lights can be switched on and off together. MicroBrite color lights
are controlled by cycling AC power to the 12 VAC transformer from a standard wall switch.
By turning the switch on and off a specific number of times, the light activates one of the
seven light show modes, fixed colors, or enables the "Hold" and "Recall" feature.

Powering on the MicroBrite Color Lights

When the MicroBrite color light is powered on, the previously selected color is displayed,
unless the HOLD or RECALL feature was previously enabled.
Note: If power to the light is off for more than five (5) seconds, the last color show mode or
fixed color that was saved will be displayed.
Selecting a MicroBrite Color Light Show Mode or Fixed Color using a Wall
Switch
MicroBrite color lights are compatible with IntelliBrite
synchronized with IntelliBrite color lights.
First switch power on to the light. A white light will momentarily illuminate, followed by the
previously selected color. To select a color show mode (1-7) or fixed color
(8-12), turn the wall switch off/on a specific number of times. Each number (1-12) shown
below corresponds to the number of times to power-cycle the switch to activate a color
light show or fixed color.
1 SAm Mode: Cycles through white, magenta, blue and green colors
(emulates the Pentair SAm color changing light).
2 Party Mode: Rapid color changing building energy and excitement.
3 Romance Mode: Slow color transitions creating a mesmerizing and
calming effect.
4 Caribbean Mode: Transitions between a variety of blues and greens.
5 American Mode: Patriotic red, white and blue transition.
6 California Sunset Mode: Dramatic transitions of orange, red and
magenta tones.
7 Royal Mode: Richer, deeper color tones.
8 Blue: Fixed color.
9 Green: Fixed color.
10 Red: Fixed color.
11 White: Fixed color.
12 Magenta: Fixed color.
13 Hold: Save the current color effect during a color light show.
14 Recall: Activate the last saved color effect.
Example: To select California Sunset Mode; turn the switch on, then off and on six (6)
times. During the off/on switching process, no illumination will occur, then a white light will
momentarily illuminate.
WARNING During the off/on switching process, before the selected color is displayed, no illumination
will occur. This operating mode is normal during the switching process. During this period the pool and spa
will be dark and precautions should be taken to avoid unforeseen accidents. Failure to observe this
warning may result in serious injury or death to pool and spa users.
MicroBrite Color and White Light Installation and User's Guide
Color Light shows and can be
®