Klein Tools MM700 Manual De Instrucciones página 10

All manuals and user guides at all-guides.com
enGliSH
connectinG teSt leaDS
Do not test if leads are improperly seated. Results could cause
intermittent display readings. To ensure proper connection, firmly
press leads into the input jack completely. Lead guard should be
flush with the meter's faceplate.
teStinG in cat iii / cat iV MeaSureMent locationS
Ensure the test lead shield is pressed firmly in place. Failure to use
the CAT III / CAT IV shield increases arc-flash risk.
5/32"
(4 mm)
teStinG in cat ii MeaSureMent locationS
CAT III / CAT IV shields may be removed for CAT II locations. This
will allow testing on recessed conductors such as standard wall
outlets. Take care not to lose the shields.
10
MM700-1390112ART.indd 10
Dwg Name: MM700-1390112ART
Dwg No: 1390112
ECO No: 20617
Pkg Dwg Ref: 1290186
Color Reference: N/A
operatinG inStructionS
.7" (18 mm)
Rev: E
ac/Dc VoltaGe (leSS tHan 1000V)
1. Insert RED test lead into VΩ jack
COM jack
4
setting.
note: The meter defaults to AC measure
the "SEL" button
DC icon on the LCD indicates which mod
NO GAP
2. Apply test leads to the circuit to be t
The meter will auto-range to display
most appropriate range.
note: If "–" appears on the LCD, the tes
the circuit in reverse. Swap the position
note: When in a voltage setting and th
readings of order mV may appear on th
is normal. By touching the test leads to
the meter will measure zero volts.
ac/Dc lo Z VoltaGe (leSS tHan 600
Voltage measurements in Low Impedanc
to identify ghost or stray voltages.
• Follow same procedure for measuring
with Function Selector switch
Do not attempt to measure voltag
lo Z setting.
9/21/2015 2:44:49 PM
operatinG inStr
,
5
, and rotate function sele
to toggle between A
11
in th
2