View Quest Retro DAB+ Guia De Funcionamiento página 2

Where to put your radio
It is important that you consider carefully in advance where your radio will
be situated and make sure that it is:
* On a flat and stable surface with sufficient ventilation
* Within 1.4metres of a power socket (if using mains power)
* Where you can fully extend the telescopic aerial
* Away from bright sunlight or heat sources, such as a radiator or naked
flame and lit candles must not be placed on the radio
* Not in a humid or very damp place such as a bathroom
Important safety instructions
This is a domestic electrical product that must only be used for its
intended purpose in accordance with these instructions
Please read this instruction manual carefully before attempting to use the
radio and retain the manual for future reference
The radio is for indoor use only
Do not move the radio while it is connected to the mains supply via the
adapter
Please ensure you plug the adaptor into a mains point that is easily
accessible in case of an accident
Clean the radio with a slightly damp cloth and do not use abrasive
cleaners
Children should be supervised to ensure that they do not play with the
radio
WARNING: If the flexible cable of the adapter is damaged, it must be
replaced by the manufacturer or his service agent or a similar qualified
person in order to avoid a hazard
Setting up
Connect the mains power lead into the socket on the back of the radio
(DC IN) and plug the power adaptor into the mains power wall socket and
switch on.
Fully extend the radio aerial in a vertical position to obtain the maximum
signal strength.
When switching on for the first time, slide the power switch on the back of
the radio to "ON", "Welcome to Digital Radio" will be displayed. Then it will
show the clock. If no further operation , the backlight will turn off and
it enters into Standby Mode. Press
Functions
1. Mode: DAB/DAB+ (BAND
AUX_IN.
2. LCD:2x16 dots matrix; black background white fonts, negative LCD
3. Power Supply: AC INPUT 100-240V ; DC_OUTPUT 5V/2A
4. Output Power: 10 W X2
5. STANDBY MODE Show Clock
button, it starts working.
5A-13F), FM (87.5MHz-108MHz), IPOD,
10W*2
GB
1